Corvette V8-7.0L (2007)
3. Press the bearing onto the pinion shaft using the J 42170 (1), J 42164 (2) or DT-48007 (2), and a hydraulic press.
Notice: Refer to Fastener Notice.
4. Install the nut onto the pinion shaft using a torque wrench, the J 42172 (1), and the J 42164 (2) or DT-48007 (2).
Tighten the nut to 500 N.m (370 lb ft).
5. Using a punch, stake the areas of the nut into the notches in the end of the pinion shaft.
6. Measure the rotating torque of the pinion shaft using the J 42164. A properly assembled pinion shaft and bearings should have a rotating torque of
1.4-2.8 N.m (12-25 lb in).
