Corvette V8-7.0L (2007)
30. Connect the VSS electrical connector.
31. Slowly raise the driveline to final installation height.
32. Remove the putty knife, if still in position.
33. Remove the jack which supported the rear of the engine.
34. Remove the tie-off retainers from the axle shafts.
35. CAREFULLY align and seat the wheel drive shafts to the differential.
36. Install the transaxle mount (2) to the differential.
37. Install the transaxle mount nuts (1).
Tighten the transaxle mount nuts to 50 N.m (37 lb ft).
38. With the aid of an assistant, begin to raise the rear suspension crossmember (still firmly attached to a transmission jack), until it contacts the
vehicle frame rails.
39. Guide the rear suspension crossmember alignment pins into the alignment holes in the vehicle frame rails, and guide the transaxle mount studs into
the mounting holes in the crossmember, then raise the crossmember until it contacts the vehicle frame rails.
