Corvette V8-7.0L (2007)
1. Position the rear bearing housing assembly into a press. Apply pressure to the housing and compress the wave washer in order to remove the snap
ring (1) from the hub.
2. Remove the snap ring (1) from the hub.
3. Position the bearing housing assembly (1) into a press in order to remove the hub and bearing assembly (2).
4. Remove the hub, with bearing (1) from the housing. The wave washer will remain in the housing.
5. Remove the snap rings (1) and bearing (2) from the hub (3).
6. Remove the propeller shaft bushing (1) and transmission input shaft bushing (2) from the hub (3) - manual transmission.
