Corvette V8-7.0L (2007)
2. Connect the rear transmission fluid cooler upper pipe to the front transmission fluid cooler upper pipe.
3. Install the transmission fluid cooler pipes clip.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the rear transmission fluid cooler upper pipe retaining bolts to the driveline support.
Tighten the bolt to 12 N.m (9 lb ft).
5. Check the transmission fluid level, add fluid if necessary.
6. Remove the drain pan.
7. Remove the driveline tunnel closeout panel.
8. Lower the vehicle. Refer to Vehicle Lifting.
Transmission Fluid Cooler Upper Pipe Replacement - Rear - To Differential Cooler
Transmission Fluid Cooler Upper Pipe Replacement - Rear - To Differential Cooler
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Lower and support the rear of the exhaust.
3. Install a drain pan under the vehicle.
Important: Cap or plug the open transmission fluid cooler pipes immediately to prevent system contamination.
