Corvette V8-7.0L (2007)
1. Remove the weatherstrip, the weatherstrip retainer, and the blow out clip.
2. Remove the screws attaching the reveal molding.
3. Remove the side reveal molding.
4. Clean the mounting surfaces.
Installation Procedure
1. Apply a 100 mm (4 in) long bead of sealant GM P/N 12345097, or equivalent, across the seam where the roof and windshield header meet.
2. Install the reward end of the side reveal molding over the lock pillar upper molding.
3. Align the applique to the slot (2) in the filler panel (1).
Notice: Refer to Fastener Notice.
