Corvette V8-7.0L VIN E (2006)
2. Install the brake caliper to the caliper mounting bracket.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the brake caliper guide pin bolts.
^
Tighten the brake caliper guide pin bolts to 31 Nm (23 ft. lbs.).
4. Remove the plug from the brake caliper opening and the brake hose.
5. Important: Install NEW copper brake hose gaskets.
Assemble the NEW copper brake hose gaskets, and the brake caliper inlet fitting bolt to the brake hose.
6. Install the brake hose and the brake caliper inlet fitting bolt to the brake caliper.
^
Tighten the brake caliper inlet fitting bolt to 45 Nm (33 ft. lbs.).
7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure).
8. Install the tire and wheel assembly.
9. Lower the vehicle.
Brake Caliper Replacement - Front (J56)
Brake Caliper Replacement - Front (J56)