Corvette V8-7.0L VIN E (2006)
1. Clean the BPMV seal surface with alcohol using a clean rag.
2. Install the seal to the BPMV if it is not cut or damaged.
3. Install the EBCM to the BPMV.
4. Notice: Refer to Fastener Notice in Service Precautions.
Tighten the 6 mounting bolts in the following sequence:
^
First pass to 3 Nm (27 inch lbs.).
^
Second pass to 6 Nm (53 inch lbs.).
5. Important: If the insulator nut was removed it must be replaced with a new insulator nut.
Install the front EBCM insulator mounting bolt.
Tighten the bolt to 14 Nm (10 ft. lbs.).
6. Install the EBCM/BPMV into the bracket.
7. Install the 2 insulator nuts (1).
Tighten the 2 insulator nuts to 12 Nm (106 inch lbs.).
8. Connect the EBCM harness connector.
Important: Both sides of the EBCM harness connector must be engaged with lever before closing.
9. Turn the ignition switch to the ON position. Do NOT start the engine.
10. Perform the Symptoms - Antilock Brake System.
