Corvette V8-7.0L VIN E (2006)
12. Position the wheel drive shaft horizontally in the bench vise.
13. Remove the outer race retaining ring from the axle shaft.
14. Remove the snap ring from the axle shaft.
15. Align the cage lands with the inner race ball tracks.
16. Reposition the cage along the axle shaft away from the inner race.
17. Wipe the grease from the inner race.
18. Remove the inner race from the axle shaft using a 3 jaw puller.
19. Remove the cage from the axle shaft.
20. Remove the seal from the axle shaft.
21. Remove the wheel drive shaft from the bench vise.
22. Clean the following thoroughly with clean solvent:
^
The inner race
^
The outer race
^
The cage
^
The balls
^
The axle shaft exposed end.
Important: All traces of old grease and any contaminates must be removed.
23. Thoroughly air dry all the parts.
