Cruze L4-1.4L Turbo (2011)
Body Control Module: Recalls
Campaign - Brake Apply Sensor Replacement
SERVICE UPDATE
Bulletin No.: 10317
Date: October 11, 2010
Subject: 10317 - Service Update for Inventory and Customer Vehicles - Malfunction Indicator Lamp (MIL) - Brake Apply Sensor (BAS) Replacement -
Expires with Base Warranty
Models:
2011 Chevrolet Cruze
Equipped with Automatic Transmission
This service update includes vehicles in dealer inventory and customer vehicles that return to the dealership for any reason. It will expire at the
end of the involved vehicle's New Vehicle Limited Warranty period.
Purpose
This bulletin provides a service procedure to replace the brake apply sensor (BAS) on certain 2011 model year Chevrolet Cruze vehicles equipped with
an automatic transmission. These vehicles may have been built with a BAS that may not function properly, indicated by the illumination of the
malfunction indicator lamp.
This service procedure should be completed as soon as possible on involved vehicles currently in dealer inventory and customer vehicles that
return to the dealer for any type of service during the New Vehicle Limited Warranty coverage period.
Vehicles Involved
A list of involved vehicles currently in dealer inventory is available on the "Service Update Bulletin Information" link under the "Service" tab in GM
GlobalConnect (US) or attached to the GlobalConnect message (Canada) used to release this bulletin. Customer vehicles that return for service, for any
reason, and are still covered under the vehicle's base warranty, and are within the VIN breakpoints provided below, should be checked for vehicle
eligibility.
Parts Information
Parts required to complete this service update are to be obtained from General Motors Customer Care and Aftersales (GMCC&A). Please refer to your
"involved vehicles listing" before ordering parts. Normal orders should be placed on a DRO = Daily Replenishment Order. In an emergency situation,
parts should be ordered on a CSO = Customer Special Order.
PN 22769186, sensor, will not be eligible for RIM.
Service Procedure
1. Adjust the driver's seat to the rear position.
2. Locate the brake pedal assembly.
3. Remove the brake apply sensor (BAS).
1. Disconnect the electrical wiring harness from the switch. While holding the connector, on the harness, press the connector down. Pull on the
harness to remove it from the vehicle.
Note
Do NOT loosen the screw to remove the BAS. Tighten the screw to a torque greater than 8 Nm(71 lb in). The screw head will break off.
Discard the screw head.
