EL Camino V6-229 3.8L (1982)
Fig. 63 - Propane Enrichment Specifications
12. Adjust idle speed to specified enriched rpm, Figs. 62 and 63, following procedure in step 3.
13. Turn mixture screws clockwise equally, 1/8 of a turn at time, until specified curb idle speed is obtained.
14. Repeats step 5 then turn OFF propane flow. If enrich rpm is not within specifications, repeat step 10-14.
15. If equipped with a throttle stop solenoid:
a. Disconnect wiring harness connector to solenoid.
b. Adjust low idle speed to specifications with throttle stop screw.
c. Connect wire to solenoid.
16. If equipped with an A/C speed-up solenoid:
a. Disconnect wiring harness connector to A/C compressor and place A/C control in ON position.
b. Momentarily open throttle to allow solenoid plunger to extend, then adjust A/C idle speed to specifications with solenoid plunger screw.
c. Turn A/C OFF and connect wiring harness connector to compressor.
17. Remove enrichment tool an install PCV tube in air cleaner. Connect vacuum hoses to proper fittings.
