Equinox AWD V6-3.4L (2008)
1. Install the engine cooling fan motor to the fan shroud.
Important: Position the fan motor to the fan shroud and insert the bolts from the front side.
2. Install the cooling fan motor bolts.
Notice: Refer to Fastener Notice .
3. Install the cooling fan motor nuts.
Tighten the nuts to 6 N.m (53 lb in).
Notice: Failure to heat the fan hub in hot tap water before installation will result in cooling fan failure due to cracking. Allowing the heated fan to
cool for more than one minute prior to installation will also result in failure due to cracking.
Important: Using hot tap water at a minimum of 49°C (120°F), hold the new fan blade hub under the running water for a minimum of 60
seconds to heat the fan blade to the temperature of the water.
Immediately after heating, position the fan blade on the fan motor drive plate.
4. Install the new engine cooling fan blade.
5. Using the GE-47827 , or equivalent turn the fan motor drive plate in the same direction of the arrow on the fan blade until the fan motor drive
plate engages to the fan blade.
6. Rotate the cooling fan blade to ensure proper rotation.
7. Install the fan shroud assembly to the vehicle. Refer to Cooling Fan and Shroud Replacement (See: Service and Repair) .
