Equinox AWD V6-3.4L (2008)
2. Install a new gasket to the valve rocker arm cover. Ensure the gasket is properly seated in the groove of the valve rocker arm cover.
Notice: Refer to Fastener Notice .
3. Install the valve rocker arm cover.
Tighten the bolts to 10 N.m (89 lb in).
4. Connect the PCV fresh air pipe (1) to the right valve rocker arm cover.
5. Install the ignition control module bracket with the ignition control module and spark plug wired still attached. Refer to Ignition Control Module
Bracket Replacement .
6. Install the generator bracket. Refer to Generator Bracket and Engine Lift Bracket Replacement (LNJ) .
7. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (See: Powertrain Management/Fuel Delivery and Air
Induction/Fuel Injector/Service and Repair/Removal and Replacement/Fuel Injector Sight Shield Replacement) .
