Equinox AWD V6-3.4L (2008)
Notice: Refer to Fastener Notice.
2. Install the mode actuator screws to the evaporator case assembly.
Tighten the screws to 1.5 N.m (13 lb in).
3. Connect the electrical connector to the mode actuator.
4. Install the communication interface module, if equipped.
5. Install the left side insulator/closeout panel.
Important: Any time a mode actuator or the HVAC control module is replaced, the HVAC control module must be calibrated to ensure
proper air distribution.
6. Calibrate the actuators. Refer to Actuator Recalibration. See: Testing and Inspection/Programming and Relearning
7. Cycle the ignition and verify proper operation.
