Equinox AWD V6-3.4L (2008)
4. Install the fuel hose/pipe to the fuel pipe retainer (2).
5. Remove the caps from the fuel pipes.
6. Connect the engine compartment fuel hose/pipe (1) to the fuel rail (4).
7. Remove the caps from the fuel pipes.
8. Connect the engine compartment fuel hose/pipe (2) to the chassis fuel hose/pipe (3).
9. Install the exhaust crossover pipe.
10. Prime the fuel system.
1. Cycle the ignition ON for 5 seconds and then OFF for 10 seconds.
2. Repeat step 7.1 twice.
3. Crank the engine until it starts. The maximum starter motor cranking time is 20 seconds.
4. If the engine does not start, repeat steps 7.1-7.4.
11. Run the engine and check for fuel system leaks.
12. Install the fuel injector sight shield.
