Equinox AWD V6-3.4L (2008)
7. Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to a new transaxle fluid temperature sensor O-ring seal (32).
8. Install a new transaxle fluid temperature sensor O-ring seal (32) into the groove of the transaxle fluid temperature sensor (36).
9. Install the transaxle fluid temperature sensor (36) into the front control valve body fluid temperature sensor bore.
10. Install the transaxle fluid temperature sensor clip (49).
Notice: Refer to Fastener Notice .
11. Install the fluid temperature sensor bolt (31).
Tighten the bolt to 10 N.m (89 lb in).
12. Connect the 8 solenoid wire connectors as follows:
*
1 blue
*
2 black
*
3 green
*
4 black
*
5 blue
*
6 gray
*
7 brown
*
8 black
13. Install the control valve body cover. Refer to Control Valve Body Cover Replacement (See: Valve Body/Service and Repair/AF33-5 - Automatic
Transaxle/Control Valve Body Cover Replacement) .
14. Perform the transmission adaptive learn procedure. Refer to Transmission Adaptive Learn and Transmission Neutral Learn (See: Testing and
Inspection/Component Tests and General Diagnostics/AF33-5 - Automatic Transaxle/Transmission Adaptive Learn and Transmission Neutral
Learn) .
