Equinox AWD V6-3.4L (2008)
Notice
Second design seals are not compatible with first design transfer cases. Installing a second design seal in a first design transfer case will create a
transmission fluid leak due to interference with the input shaft.
Seal Installation
Installing the replacement seal to the proper depth is critical. Use the DT-48078 - Inner Drive Shaft Seal installer with a J 8092 - Driver Handle to install
the seal 2.8 mm (0.11 in) (a) from the end of the input shaft. Refer to the Front Drive Axle Inner Shaft Seal Replacement procedure in SI.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table above.
Disclaimer
Technical Service Bulletin # 08-07-30-009B
Date: 080501
A/T - 4T80E, Slips in Gear/L/H Axle Seal Leaks
TECHNICAL
Bulletin No.: 08-07-30-009B
