Equinox AWD V6-3.4L VIN F (2006)
5. Remove the caps or plugs from the brake caliper opening and the brake hose.
6. Important: Do not reuse the copper brake hose gaskets.
Install NEW copper brake hose gaskets to the brake hose-to-caliper bolt and to the brake hose.
7. Install the brake hose and the brake hose-to-brake caliper bolt to the brake caliper.
^
Tighten the bolt to 44 Nm (32 ft. lbs.).
8. Bleed the hydraulic brake system.
9. Remove the wheel nuts retaining the brake rotor to the wheel hub.
10. Install the tire and wheel assembly.
11. Lower the vehicle.
12. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
13. Slowly release the brake pedal.
14. Wait 15 seconds, then gradually apply the brake pedal approximately 2/3 of its travel distance again until a firm brake pedal apply is obtained.
This will properly seat the brake caliper pistons and brake pads.
