Equinox AWD V6-3.4L VIN F (2006)
6. Connect the heater outlet hose (2) to the heater outlet pipe.
7. Position the heater outlet hose clamp (1) over the heater outlet pipe connection.
8. Connect the electrical connector to the EGR valve.
9. Connect the electrical connector to the EVAP canister purge solenoid.
10. Connect the EVAP pipe to the EVAP canister purge solenoid.
11. Reposition the MAP sensor.
12. Install the MAP sensor bracket (2) and bolt (3).
Tighten the bolt to 10 Nm (89 inch lbs.).
13. Install the air cleaner air intake duct.
14. Fill the cooling system.
15. Install the injector sight shield.
