Equinox AWD V6-3.4L VIN F (2006)
1. Install the bolt to the drive belt tensioner.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the drive belt tensioner and bolt as an assembly to the generator bracket.
^
Tighten the bolt to 50 Nm (37 ft. lbs.).
3. Insure the drive belt is properly centered on all the pulleys except the right idler pulley (3).
4. Using J 39914 rotate the drive belt tensioner away from the drive belt.
5. Install the drive belt to the right idler pulley (2).
6. Carefully release J 39914 allowing the drive belt tensioner (8) to come in contact with the drive belt.
7. Remove J 39914 from the drive belt tensioner (8).
8. Inspect the drive belt to insure the belt is properly centered on all the pulleys (1-8).
9. Install the air cleaner intake duct.
