Equinox AWD V6-3.4L VIN F (2006)
Tighten the screws to 1.5 N.m (13 lb in).
NOTE: Refer to Fastener Notice.
3. Connect the electrical connector to the air temperature actuator.
4. Calibrate the actuators by simultaneously pushing the A/C and RECIRC buttons on the HVAC control module three times each, within two
seconds of initial push.
-
The A/C and RECIRC button LED's will flash while this calibration is taking place.
-
The calibration will take anywhere between 10 to 30 seconds depending on battery voltage.
-
The LEDs will quit flashing when the calibration is complete.
IMPORTANT: Any time an actuator or the HVAC control module is replaced, the HVAC control module must be calibrated to ensure proper air
distribution.
5. Cycle the ignition and verify proper operation.
6. Install the instrument panel compartment.
