Equinox AWD V6-3.4L VIN F (2006)
2. Install the mode actuator screws to the evaporator case assembly.
Tighten the screws to 1.5 N.m (13 lb in).
NOTE: Refer to Fastener Notice.
3. Connect the electrical connector to the mode actuator.
4. Install the communication interface module, if equipped.
5. Install the left side insulator/closeout panel.
6. Calibrate the mode actuators by simultaneously pushing the A/C and RECIRC buttons on the HVAC control module 3 times each, within 2
seconds of initial push.
-
The A/C and RECIRC button LED's will flash while this calibration is taking place.
-
The calibration will take anywhere between 10-30 seconds depending on battery voltage.
-
The LED's will quit flashing when the calibration is complete.
IMPORTANT: Any time a mode actuator or the HVAC control module is replaced, the HVAC control module must be calibrated to ensure proper
air distribution.
7. Cycle the ignition and verify proper operation.
