Equinox AWD V6-3.4L VIN F (2006)
Transmission Shift Position Indicator Lamp: Service and Repair
TRANS FLOOR SHIFT CONTROL INDICATOR LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Remove the instrument panel (I/P) trim bezel.
2. Disconnect the electrical connector from the PRNDL assembly.
3. Remove the screws that retain the PRNDL assembly to the I/P bezel. Remove the PRNDL assembly.
INSTALLATION PROCEDURE
1. Align the PRNDL assembly with the trim bezel and fasten in place.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 2.5 N.m (22 lb in).
2. Connect the electrical connector to the PRNDL assembly.
3. Install the I/P trim bezel.
4. Test the PRNDL assembly for proper operation.