Equinox AWD V6-3.4L VIN F (2006)
1. Inspect the foam seal. If the seal is damaged, replace the seal using Kent Industries adhesive back foam tape P/N 46485 (or equivalent).
2. Install the filter housing to the vehicle.
3. Install the new seal nuts to the filter housing.
Tighten the nuts to 9 N.m (80 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: New seal nuts must be used when installing passenger compartment air filter housing to prevent leaks.
4. Install the LH air inlet panel.
5. Install the RH air inlet panel.
