Equinox AWD V6-3.4L VIN F (2006)
Fuel Filler Hose: Service and Repair
FILLER TUBE REPLACEMENT
REMOVAL PROCEDURE
1. Ensure that the fuel level in the tank is less than 1/4 full. If necessary, drain the fuel tank to at least this level. Refer to Fuel Tank Draining
Procedure.
IMPORTANT: Replacement fuel filler tube hoses do not come equipped with hose clamps. Obtain replacement hose clamps prior to beginning this
service procedure.
CAUTION: Do not allow smoking or the use of open flames in the area where work on the fuel or EVAP system is taking place. Anytime
work is being done on the fuel system, disconnect the negative battery cable, except for those tests where battery voltage is required.
2. Remove the fuel filler cap.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Remove the right rear wheel and tire.
5. Remove the right rear wheelhouse inner liner.
6. Loosen the fuel filler tube hose clamp.
7. Disconnect the fuel filler tube, the fuel filler vent tube, and the fresh air hose from the fuel tank.
8. Remove the fuel filler tube bracket bolts (2).
