Equinox AWD V6-3.4L VIN F (2006)
Camshaft Position Sensor: Service and Repair
CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the camshaft position (CMP) sensor electrical connector.
2. Remove the CMP sensor bolt.
3. Remove the CMP sensor.
4. Inspect the CMP sensor O-rings for wear, cracks, or leakage if the sensor is being reused. Replace the O-rings if damaged.
INSTALLATION PROCEDURE
1. Lubricate the CMP sensor O-rings with clean engine oil.
2. Install the CMP sensor.
3. Install the CMP sensor bolt.
Tighten the bolt to 10 N.m (89 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Connect the CMP sensor electrical connector.
