Equinox AWD V6-3.4L VIN F (2006)
32. Completely cover the windshield and the front door openings with a drop cloth.
33. Stretch out all of the deployment harness wires on the passenger side of the vehicle to their full length.
34. Deploy each deployment loop one at a time.
35. Place a power source, 12-volt minimum/2-amp minimum, such as a vehicle battery, near the shorted end of the harnesses.
36. Separate one set of wires and touch the wire ends to the power source in order to deploy the seat belt pretensioners.
37. Disconnect the deployment harness from the power source and twist the wire ends together.
38. Continue the same process with the remaining deployment harnesses that are available.
39. Stretch out all the deployment harness wires on the driver side of the vehicle to their full length.
40. Place a power source, 12-volt minimum/2-amp minimum, such as a vehicle battery, near the shorted end of harness.
41. Separate one set of wires and touch the wire ends to the power source in order to deploy the seat belt pretensioner.
42. Remove the drop cloth from the vehicle.
43. Disconnect all harnesses from the vehicle.
44. Discard the harnesses.
45. Scrap the vehicle in the same manner as a non - Restraint Systems equipped vehicle.
46. If one or more of the seat belt pretensioners did not deploy, perform the following steps to remove the undeployed seat belt pretensioner from the
vehicle, refer to Seat Belt Retractor Pretensioner Replacement - Left Front or Seat Belt Retractor Pretensioner Replacement - Right Front.
47. Call the Technical Assistance Group for further assistance.
