Equinox AWD V6-3.4L VIN F (2006)
Shifter A/T: Service and Repair
Shift Control Knob Replacement
Shift Control Knob Replacement
Removal Procedure
1. Apply the parking brake.
2. Rotate the key to the RUN position, however do NOT start the vehicle.
3. Move the shift control lever rearward to one of the low gear positions.
4. Carefully insert a small flat bladed tool between the trim ring (2) and the shift knob (1). Apply careful downward pressure to the shift knob trim
ring to separate the trim ring from the shift knob. The trim ring will drop down approximately 13.0 mm (0.5 inch) exposing the shift knob
retaining screw.
5. Loosen the shift control knob screw (1) approximately 4-5 turns. It is not necessary to fully remove the screw from the shift control knob.
