Equinox AWD V6-3.4L VIN F (2006)
3. Install the J 44394 to the transaxle oil seal.
4. Install the intermediate drive shaft to the bearing retainer bracket and the transaxle.
5. Remove the J 44394 when the intermediate shaft splines pass the oil seal.
6. Ensure that the intermediate drive shaft is fully seated by grasping the intermediate drive shaft and attempting to pull free of the transaxle.
7. Position the bearing retainer to the support bracket.
8. Install the bearing retainer bolts.
^
Tighten the bolts to 30 Nm (22 ft. lbs.).
9. Install the O-ring seal to the intermediate drive shaft.
10. Install a new wheel drive shaft retaining ring to the intermediate drive shaft.
11. Install the right wheel drive shaft.
12. Install the right tire and wheel assembly.
13. Lower the vehicle.
Intermediate Shaft Replacement - With RPO L66
Intermediate Shaft Replacement (L66)
^
Tools Required
-
J 2619-01 Slide Hammer
-
J 44394 Seal Protector
-
J 44467 Output Shaft Assembly Remover and Installer
Removal Procedure
