Equinox AWD V6-3.4L VIN F (2006)
1. Install the J 44394 to the transaxle oil seal.
2. Install the intermediate drive shaft to the transaxle.
3. Remove the J 44394 when the intermediate shaft splines pass the oil seal.
4. Ensure that the intermediate drive shaft is fully seated by grasping the intermediate drive shaft and attempting to pull free of the transaxle.
5. Position the support bracket to the engine.
6. Notice: Refer to Fastener Notice in Service Precautions.
Install the support bracket bolts.
^
Tighten the bolts to 50 Nm (37 ft. lbs.).
7. Install the O-ring seal to the intermediate drive shaft.
8. Install a new wheel drive shaft retaining ring to the intermediate drive shaft.
9. Install the right wheel drive shaft.
10. Install the right tire and wheel assembly.
11. Lower the vehicle.
Wheel Drive Shaft Inner Joint and Seal Replacement - Front
Wheel Drive Shaft Inner Joint and Seal Replacement - Front
^
Tools Required
-
J 35910 Drive Axle Seal Clamp Pliers
Disassembly Procedure
