Equinox AWD V6-3.4L VIN F (2006)
13. Place a block of wood against the CV joint spindle and tap on the block of wood until the CV joint inner race engages the retaining ring.
14. Slide the large diameter of the seal over the outside of the CV race and locate the lip of the seal in the housing groove.
15. Install the large seal retaining clamp over the seal and close using the J 35910
16. Inspect the gap dimension on the clamp ear. Continue tightening until the gap dimension is reached.
Dimension equals 1.9 mm (5/64 inch).
17. Remove the wheel drive shaft from the bench vise.
18. Distribute the grease within the outer CV joint by rotating the joint in a circular motion four to five times.
Wheel Drive Shaft Outer Joint and Seal Replacement - Rear
Wheel Drive Shaft Outer Joint and Seal Replacement - Rear
^
Tools Required
-
J 35910 Drive Axle Seal Clamp Pliers
Disassembly Procedure
1. Clamp the drive axle shaft in a soft jawed vice.
