Equinox AWD V6-3.4L VIN F (2006)
1. Clean any dirt or foreign material from the seal bore area.
2. Using the J 44809 , install the NEW output shaft seal.
3. Install the stub shaft using the J 6125-1B and J 38868 .
4. Install a NEW retainer ring on the stub shaft.
5. Install the right wheel drive shaft.
6. Remove the fluid fill plug and check the fluid level. Fluid should be to the bottom of the fill hole threads. Add synthetic gear lubricant GM P/N
12378514 (Canadian P/N 88901045) if necessary.
7. Clean and fill plug and apply adhesive GM P/N 12345493 (Canadian P/N 10953488) to the threads.
8. Notice: Refer to Fastener Notice in Service Precautions.
