Equinox FWD V6-3.4L VIN F (2005)
5. Remove the liftgate window from the urethane adhesive.
*
Leave a base of urethane approximately 2 mm (0.078 in) on the pinch-weld flange.
*
The only suitable lubrication is clear water.
*
Use J 24402-A , J 39032 or equivalent in order to remove the window.
6. With the aid of an assistant, remove the window from the vehicle.
Installation Procedure
1. Install the liftgate window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows (Windshield) (See: Windows and
Glass/Windows/Service and Repair/Urethane Adhesive Installation of Stationary Windows (Windshield))Urethane Adhesive Installation of
Stationary Windows (Liftgate) (See: Windows and Glass/Windows/Service and Repair/Urethane Adhesive Installation of Stationary Windows
(Liftgate)) .
2. Connect the liftgate window defogger electrical connectors to the bus bar.
3. Install the liftgate trim. Refer to Trim Panel Replacement - Liftgate (See: Trunk / Liftgate Interior Trim Panel/Service and Repair) in Body Rear
End.
4. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
5. Close the liftgate.
