Equinox FWD V6-3.4L VIN F (2005)
Ignition Cable: Service and Repair
SPARK PLUG WIRE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the injector sight shield.
2. Remove the spark plug wires (1) from the left side spark plugs.
NOTE: Twist the spark plug boot one-half turn in order to release the boot. Pull on the spark plug boot only. Do not pull on the spark plug wire or
the wire could be damaged.
3. Remove the spark plug wires from the retaining clips (2).
4. Remove the spark plug wires (1) from the right side spark plugs.
5. Remove the spark plug wires from the retaining clips (2).
6. Remove the spark plug wires from the ignition coil/control module.
7. Remove the spark plug wires from the engine.
8. If you are replacing the spark plug wires, transfer any of the following components:
-
Boot heat shields
-
Spark plug wire conduit
-
Spark plug wire retaining clips