Express 1/2 Ton Van V6-4.3L VIN X (2003)
Cross-Member: Service and Repair
Front Engine Crossmember Replacement (RWD)
Front Engine Crossmember Replacement (RWD)
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) in General
Information.
2. Disconnect the electrical wiring harness connectors from the engine crossmember.
3. Remove the engine crossmember mounting bolts.
4. Remove the engine crossmember.
Installation Procedure
1. Install the engine crossmember.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the engine crossmember mounting bolts.
Tighten the bolts to 120 N.m (89 lb ft).
3. Connect the electrical wiring harness connectors to the engine crossmember.
4. Lower the vehicle.
