Express 1/2 Ton Van V6-4.3L VIN X (2003)
10. Remove the brake pads from the brake caliper bracket. Note the orientation.
11. Remove and discard the anti-rattle clips from the brake caliper mounting bracket.
Installation Procedure
1. Install the anti-rattle clips to the brake caliper bracket.
2. Install the brake caliper.
3. Install the brake pads to the brake caliper bracket Place the new pads in the same orientation as noted during removal.
4. Install the tire and wheel assembly.
5. Lower the vehicle.
6. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
7. Slowly release the brake pedal.
8. Wait 15 seconds, then repeat steps 7-8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
9. Fill the master cylinder reservoir to the proper level with clean brake fluid.
10. Burnish the brakes pads and rotors as necessary.
