Express 1/2 Ton Van V6-4.3L VIN X (2003)
1. Install the cable.
2. Snap the retainer tabs into the frame bracket.
3. Connect the front cable to the intermediate cable.
4. Route the cable in through the floor pan and engage the grommet.
5. Remove the safety stands.
6. Lower the vehicle.
7. Install the cable anchor to the stud on the floor.
Notice:
Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Fastener Notice
8. Install the anchor nut.
Tighten the nut to 13 Nm (115 inch lbs.)
9. Roll the carpet into place.
10. Install the park brake pedal.
11. Adjust the park brake system.
Rear - Left
Park Brake Cable Replacement - Left Rear
Removal Procedure
1. Release the park brake.
2. Disable the park brake cable automatic adjuster.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
