Express 1/2 Ton Van V6-4.3L VIN X (2003)
27. Connect the following electrical connectors:
^
The A/C compressor clutch (1), if equipped
^
The EGR valve (2)
^
The ECT sensor (3)
28. Install the ground wire (4) and the nut to the water outlet stud.
^
Tighten the ground wire nut to 10 Nm (88 inch lbs.).
29. Install the cruise control cable, if equipped to the throttle shaft and the accelerator control cable bracket.
30. Install the accelerator control cable to the throttle shaft and the accelerator control cable bracket.
31. Refill the cooling system.
32. Install the air cleaner assembly.
33. Connect the battery negative cable.
34. Install the engine cover.
