chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Distributor Overhaul|Page 1445 > < Distributor Overhaul
Page 2
background image

4. Note the locating holes that the rotor was removed from:

-

The rotor screw holes (1)

-

The rotor locator pin holes (2)

5. Line up the square-cut hole in the vane wheel with the camshaft position (CMP) sensor.

6. Remove the two screws that hold the camshaft position (CMP) sensor.
7. Discard the screws.

Distributor Overhaul|Page 1445 > < Distributor Overhaul