Express 1/2 Ton Van V6-4.3L VIN X (2003)
Fuel Gauge Sender: Service and Repair
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure.
4. Remove the fuel tank.
5. Remove the fuel sender assembly.
6. Disconnect the fuel pump electrical connector (5).
7. Remove the electrical connector retaining clip (6) from the fuel level sensor.
8. Disconnect the electrical connector (7) from the fuel level sensor under the fuel sender cover.
9. Remove the retaining clip (4) from the fuel level sensor.
10. Squeeze the locking tangs and remove the fuel level sensor (3).
INSTALLATION PROCEDURE
1. Install the fuel level sensor (3).
2. Install the retaining clip (4) to the fuel level sensor.
3. Connect the electrical connector (7) to the fuel level sensor.
4. Connect the electrical connector retaining clip (6) to the fuel level sensor.
5. Connect the fuel pump electrical connector (5).
6. Install the fuel sender assembly.
