Express 1/2 Ton Van V6-4.3L VIN X (2003)
3. Install the 2-4 servo assembly into the 2-4 servo bore.
4. Install the servo cover and O-ring seal
5. Install the J 29714-A.
6. Tighten the bolt on the J 29714-A in order to compress the servo cover
7. Install the servo cover retaining ring.
8. Remove the J 29774-A from the oil pan flange.
Notice: Refer to Fastener Notice in Service Precautions.
9. Install the oil pan boll
^
Tighten the oil pan bolt to 11 Nm (97 inch lbs.).
10. Install the 2 heat shield retaining bolts and the heat shield from the transmission.
^
Tighten the bolts to 17 Nm (13 ft. lbs.).
11. Lower the vehicle.
12. Fill the transmission to the propel level with approved fluid.
