Express 1/2 Ton Van V8-5.7L VIN R (1999)
Access Cover: Service and Repair
Seat Replacement - Bucket
SEAT REPLACEMENT
REMOVAL PROCEDURE
1. Disable the Sir.
CAUTION: Refer to SIR Caution in Service Precautions.
2. If seat is equipped with power seat motors, disconnect the electrical connector from the seat assembly.
3. Remove the nuts (3) that retain the seat assembly to the vehicle.
4. Remove the front seat assembly from the vehicle.
INSTALLATION PROCEDURE
1. Position the front seat assembly into the vehicle.
2. Install the nuts (3).
NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints,
lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping
force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts
and systems.
Tighten
Tighten the nuts to 60 Nm (44 lb ft).
