Express 1/2 Ton Van V8-5.7L VIN R (1999)
Backing Plate: Service and Repair
REMOVAL PROCEDURE
CAUTION: Avoid taking the following actions when you service wheel brake parts:
^
Do not grind brake linings.
^
Do not sand brake linings.
^
Do not clean wheel brake parts with a dry brush or with compressed air.
Some models or aftermarket brake parts may contain asbestos fibers which can become airborne in dust. Breathing dust with asbestos fibers may cause
serious bodily harm. Use a water-dampened cloth in order to remove any dust on brake parts. Equipment is available commercially in order to perform
this washing function. These wet methods prevent fibers from becoming airborne.
1. Raise the vehicle and support the vehicle with safety stands.
2. Remove the tire and the wheel.
3. Install the pin into the park brake lever.
4. Remove the rear brake drum.
5. Remove the rear brake shoes.
6. Remove the rear brake cylinder.
7. Remove the rear brake anchor pin.
8. Remove the rear brake backing plate retaining bolts and washers.
9. Remove the rear brake backing plate from the vehicle.
INSTALLATION PROCEDURE
1. Install the rear brake backing plate.
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Install the rear brake backing plate retaining bolts and washers.
^
Tighten the rear brake backing plate retaining bolts to 140 Nm (104 ft. lbs.).
