Express 1/2 Ton Van V8-5.7L VIN R (1999)
10. Immerse the opposite end of the hose into a container partially filled with clean brake fluid.
NOTICE: Refer to Fastener Notice in Service Precautions.
11. Slowly open the bleeder valve at least 3/4 of a turn. Allow the fluid to flow until you see no air in the fluid.
^
Tighten the wheel cylinder or caliper bleeder valve to 13 Nm (110 inch lbs.).
12. Repeat steps 7-12 at every wheel.
13. Check for softness in the brake pedal action. Repeat the bleeding procedure if the brake pedal action is soft.
14. Disconnect the hose from the bleeder adapter.
15. Remove the J 29567.
16. Fill the master cylinder to the proper level.
