Express 1/2 Ton Van V8-5.7L VIN R (1999)
3. Connect the brake pipe to the rear brake hose.
^
Tighten the rear brake pipe to the rear brake hose to 12 Nm (106 inch lbs.).
4. Connect the brake pipe to the Electronic Brake Control Module (EBCM) unit.
^
Tighten the rear brake pipe to the EBCM unit to 20 Nm (15 ft. lbs.).
5. Bleed the hydraulic system.
Brake Pipe Replacement (Rear Brake Rear Pipe)
REMOVAL PROCEDURE
CAUTION: Refer to Brake Pipe Replacement Caution in Service Precautions.
IMPORTANT: Brake pipes that run parallel to each other must maintain a 6 mm (1/4 inch) clearance.
1. Disconnect the rear brake front pipe from the rear brake rear pipe at the brass fitting.
