Express 1/2 Ton Van V8-5.7L VIN R (1999)
2. Disconnect the electrical connector from the fluid pressure alarm switch.
3. Remove the fluid pressure alarm switch from the vehicle.
INSTALLATION PROCEDURE
NOTICE: Refer to Fastener Notice in Service Precautions.
1. Install the fluid pressure alarm switch to the vehicle.
^
Tighten the fluid pressure alarm switch to 12 Nm (106 inch lbs.).
2. Connect the negative battery cable.
Brake Booster Push Rod Gauging Procedure
^
Tools Required
-
J 37839 Push Rod Height Gauge
1. Gauge the piston rod. Use the J 37839. Check the maximum and minimum rod length.
