Express 1/2 Ton Van V8-5.7L VIN R (1999)
9. Remove the left valve cover from the engine.
10. Clean all sealing surfaces.
Installation Procedure
1. Install the left valve cover to the engine.
2. Install the power steering pump pulley to the power steering pump.
-
Install the power steering pump bracket onto the stud.
-
Install the three bolts finger tight.
-
Install the two nuts to the back of the power steering pump finger tight.
Notice: Refer to Fastener Notice in Service Precautions.
-
Tighten the nuts and the bolts to 44 Nm (32 ft. lbs.).
3. Install the power steering pump mounting bracket using the following procedure:
-
Install the A/C compressor, if equipped.
-
Connect the coolant sender electrical connector.
