Express 1/2 Ton Van V8-5.7L VIN R (1999)
6. Remove the hardware retaining section of pipe to be replaced (1). Note location of attaching hardware for installation.
7. Remove the section of pipe and hoses.
8. Remove rust or burrs from the engine compartment fuel pipes by the following procedure:
8.1.
Use emery cloth in a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface.
8.2.
Using a clean shop towel, wipe off the male tube ends.
8.3.
Inspect all the connectors for dirt and burrs. Clean or replace the components/assemblies as required.
8.4.
Disconnect the fuel feed and return pipe quick connects at the fuel tank pipe harness (2).
8.5.
Remove the section of fuel pipe from the hardware retaining mounts (1).
8.6.
Remove the fuel tank.
8.7.
Refer to Fuel Tank Replacement (Passenger/Cargo Van) and Fuel Tank Replacement (Commercial/RV Cutaway Van).
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Connect the fuel feed and return pipes to the engine fuel pipes (1).
