chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Inflator Module Replacement|Page 8510 > < Inflator Module Replacement|Page 8508
Page 6
background image

1. Turn the ignition switch to the OFF position.
2. Remove the ignition key.
3. Put on safety glasses.
4. Inspect the J 38826 and the appropriate pigtail adapter for damage. Replace as needed.
5. Short the two SIR deployment harness (1) leads together using one banana plug seated into the other.
6. Connect the appropriate pigtail adapter (2) to the SIR deployment harness (1).
7. Remove the Inflatable Restraint Steering Wheel Module.
8. Remove the horn lead from the back of the module, if equipped.
9. Remove all horn/steering wheel control buttons from the module, if equipped.

Caution:  When you are carrying an undeployed inflator module:

^

Do not carry the inflator module by the wires or connector on the inflator module

^

Make sure the bag opening points away from you

When you are storing an undeployed inflator module, make sure the bag opening points away from the surface on which the inflator module
rests. When you are storing a steering column, do not rest the column with the bag opening facing down and the column vertical. Provide free
space for the air bag to expand in case of an accidental deployment. Otherwise, personal injury may result.

Place the module with the vinyl trim cover facing up and away from the surface on a work bench.

Inflator Module Replacement|Page 8510 > < Inflator Module Replacement|Page 8508