Express 1/2 Ton Van V8-5.7L VIN R (1999)
Installation Procedure
1. Install the Inflatable Restraint Front End Discriminating Sensor (3) to the front end lower tie bar (1).
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the Inflatable Restraint Front End Discriminating Sensor mounting fasteners (4).
Tighten
Tighten fasteners to 10 N.m (89 lb in).
3. Connect the Inflatable Restraint Front End Discriminating Sensor harness connector to the sensor.
4. Install the Connector Position Assurance (CPA) to the Inflatable Restraint front end discriminating sensor harness connector.
5. Remove the safety stands and lower the vehicle.
6. Enable the SIR system.
