Express 1/2 Ton Van V8-5.7L VIN R (1999)
Center Link: Service and Repair
Connecting Rod Replacement
REMOVAL PROCEDURE
-
Tools Required
-
J 24319-B Universal Steering Linkage Puller
IMPORTANT: Use the proper tool in order to separate all the ball joints.
1. Raise the vehicle. Support the vehicle with suitable safety stands.
2. Remove the prevailing torque nut (1) from the relay rod (2) ball stud at the pitman arm. Discard the prevailing torque nut (1).
3. Use the J 24319-B in order to remove the connecting rod (4) from the relay rod (2).
4. Remove the prevailing torque nut (1) from the pitman arm (3) ball stud. Discard the prevailing torque nut (1).
5. Use the J24319-B in order to remove the connecting rod (1) from the pitman arm (3).
6. Remove the connecting rod from the vehicle.
7. Inspect the ball stud threads for damage.
8. Inspect the ball stud seals for excessive wear.
9. Clean the threads on the ball stud.
INSTALLATION PROCEDURE
-
Tools Required
-
J 29193 Steering Linkage Installer (12 mm)
